The 10 Most Unanswered Questions about

June 14, 2019

Miscellaneous

Comments Off on The 10 Most Unanswered Questions about


Ceramic Motor Seal

Engine overheat is an inevitable problem in any car, which is also expensive to repair and this happens as a result of head gasket leaks. But don’t worry because there’s an easy alternative for that and it is through the use of ceramic motor seal. Cylinder head gasket leaks are really a problem which causes plague in the internal combustion engine no matter what its model, make or year. Whether it is because of engine overheat or due to high mileage and tear and wear, the cylinder head gaskets may result to leak and other issues.

When there’s leak in the cylinder head gasket, this is an indication that there is a leak in engine coolant either to crankcase of the engine or into several cylinders of the engine. If you like to learn more about this, you may visit this site and keep on reading.

As for the severity of leaks in your head gasket, it can be minor to serious. In the former, the car is still in a driveable condition but it will suffer from diminished engine performance, overheating and slow coolant consumption. In more serious cases however, the engine can suffer from major engine performance problems and overheating, blow white smoke out the tail pipes and excess coolant contamination. However, in a more serious case, the head gasket leak will make the car not suitable for driving and will require total engine replacement. You can view here to see the full consequence of not attending to head gasket leak ASAP.

If you use Irontite, it will work from within of the car by sealing the head gasket leaks by utilizing the car’s cooling passages where it’ll be transported on where the leak is. Keep in mind that before you proceed with the repair, it is recommended to have your car diagnosed properly to know the real score from the problem.

Assuming that everything is a go, here are few of the things that you must do.

#1. Make sure to check the back of Thoro-Flush to be able to see how it should be used correctly.

#2. Find the radiator cap and pour in the engine block sealer straight to the engine.

#3. Once you’re done pouring the right amount of the engine block sealer to engine coolant, make sure it’s at the proper level and get a new cap.

#4. Start the engine and turn the heater on to maximum flow and heat.

#5. Keep the engine running in idle for at least 15 minutes or for how long as instructed on your engine blocks sealer.

These steps will get your car’s engine running in good condition, so do this now!

Supporting reference: pop over here